DIRECTIONS FOR USE:

1. When preparing or using this product, take care not to splash, drip or use on surfaces such as ceramic tile, linoleum, formica brand counter surfaces, carpeting, etc. as etching or discoloration of these surfaces may take place.

2. This product is intended only for use as a pool and spa filter cleaner.

SAND FILTERS:

Turn off inlets and outlets for all chemical feeders. Close main drain and place filter in backwash position. Slowly add 1 pint of this product through strainer while backwashing. This product can also be added through the sand fill port. Run filter until product begins to come out of the backwash water or until the product is seen through a filter viewing cell. Soak filter for 30 to 60 minutes. After soaking, backwash filter until water comes out clean and foam clears. Reverse procedure and start normal filter operation. For sand filters containing more than 150 pounds of sand, add 1 quart of this product.

CARTRIDGE FILTERS:

Stop filter operation. Bleed off excess pressure through the filter safety valve. Open filter unit, remove cartridge from filter, and rinse excess loose dirt with a water hose from top to bottom. Place cartridge into a bucket and add 1 pint of this product and 2 1/2 gallons water. Make sure filter unit is completely covered by the cleaner. Soak 30 to 60 minutes. After soaking, rinse with hose at maximum pressure to remove excess filter cleaner or until foam residue is completely washed off. Re-install cartridge and resume normal filter operation.

DIATOMACEOUS EARTH FILTERS:

Stop filter operation. Bleed off excess pressure through safety valve. Remove filter elements (grids) from filter and rinse off excess dirt with a hose from top to bottom. Place grids in a bucket and add 1 pint of this product and 2 1/2 gallons water. Make sure grids are fully immersed in cleaner. Soak 30 to 60 minutes. After soaking, rinse out excess filter cleaner with hose at maximum pressure. Re-install grid and add new filter media. Resume normal filter operation.

Will this work with my filter type?

Yes, this filter cleaner is designed for use with hot tub, spa, and pool filters, including cartridge, sand, and DE filters, when used according to label directions.

How long do I soak my filter in the cleaning solution?

This filter cleaner is formulated to work within a shorter soak time. A soak of approximately 30–60 minutes is typically sufficient, depending on the level of buildup and filter condition.

How do I clean my filter?

Proper filter cleaning generally involves removing the filter, rinsing off loose debris, soaking it in a filter cleaning solution, and rinsing thoroughly before reinstalling. Always follow product instructions and any guidance provided by your filter manufacturer.

Where is it made?

Our product is made, packaged, and shipped from the USA.